Connecting The Loudspeaker Outputs - Renkforce E-SA9 Bedienungsanleitung

b) Connecting the loudspeaker outputs
The line towards the loudspeakers must be a bifilar cable. Insulate all connecting terminals.
Make sure that there are no sharp edges which could damage the cables. Only use loudspea-
kers which have a sufficiently high loading capacity (see „Technical Data").
Connect the loudspeakers directly with the amplifier.
Do not use headphone adapters or distribution boxes. If you are unsure about anything, please
contact a specialist.
Make sure that all loudspeakers have the correct polarity, i.e. the plus and minus signs must
match.
This amplifier has been built for a loudspeaker impedance from 4 to 8 ohm. Only connect one
loudspeaker to each output.
If you connect loudspeakers to the surround outputs (12) of the amplifier, the minimum impe-
dance of the loudspeakers connected to the SPEAKER clamps (13) is 8 Ohm each.
• To open the loudspeaker clamps, press the red/black plastic surface. Slide the stripped end of the lou-
dspeaker cable into the aperture and release the plastic surface. The loudspeaker cable is clamped and
good contact is guaranteed.
Connect the loudspeakers to the clamps marked with SPEAKER (13).
• Connect the (+) pole of the left loudspeaker with the red speaker clamps marked with „L+".
• Connect the (-) pole of the left loudspeaker with the black speaker clamp marked with „L-".
• Connect the (+) pole of the right loudspeaker with the red speaker clamps marked with „R+".
• Connect the (-) pole of the right loudspeaker with the black speaker clamp marked with „R-".
31