Connecting the loudspeaker outputs
The line towards the loudspeakers must be a bifilar cable. Insulate all connecting terminals.
Make sure that there are no sharp edges which could damage the cables. Only use loudspeakers
which have a sufficiently high loading capacity (see „Technical Data").
Connect the loudspeakers directly with the amplifier. Do not use headphone adapters or
distribution boxes. If you are unsure about anything, please contact a specialist.
Make sure that all loudspeakers have the correct polarity, i.e. the plus and minus signs must
match.
This amplifier has been built for a loudspeaker impedance from 6 to 8 ohm. Never connect
loudspeakers with a lower impedance. Only connect one loudspeaker to each output.
Connect the loudspeakers to the clamps marked with SPEAKERS (13).
•
Connect the (+) pole of the left loudspeaker with the red speaker clamps marked with „LEFT+".
•
Connect the (i) pole of the left loudspeaker with the black speaker clamps marked with „LEFT-".
•
Connect the (+) pole of the right loudspeaker with the red speaker clamps marked with „RIGHT+".
•
Connect the (-) pole of the right loudspeaker with the black speaker clamps marked with „RIGHT-".
R I G H T
L E F T
L
_
_
SP E A K E RS 6 ~ 8
L
R
33