Connecting The Loudspeaker Outputs - Renkforce E-SA9M Bedienungsanleitung

Connecting the loudspeaker outputs

The line towards the loudspeakers must be a bifilar cable. Insulate all connecting terminals.
Ensure there are no sharp edges which could damage the cables. Only use loudspeakers which
have a sufficiently high loading capacity (see „Technical Data").
Connect the loudspeakers directly with the amplifier.
Do not use headphone adapters or distribution boxes. If you are unsure about anything, please
contact a specialist.
Make sure that all loudspeakers have the correct polarity, i.e. the plus and minus signs must
match.
This amplifier has been designed for a loudspeaker impedance of 8 Ohm on each channel. Only
connect one loudspeaker to each output.
• To open the loudspeaker clamps, press the red/black plastic surface. Slide the stripped end of the loudspeaker
cable into the aperture and release the plastic surface. The loudspeaker cable is clamped and good contact is
guaranteed.
Connect the loudspeakers to the clamps marked with SPEAKER (21).
• Connect the (+) pole of the left loudspeaker with the red speaker clamps marked with „L+".
• Connect the (-) pole of the left loudspeaker with the black speaker clamp marked with „L-".
• Connect the (+) pole of the right loudspeaker with the red speaker clamps marked with „R+".
• Connect the (-) pole of the right loudspeaker with the black speaker clamp marked with „R-".
31