Initial Operation; Handling - Renkforce E-SA9 Bedienungsanleitung

8. Initial operation

Please note that sound controls that are turned up very high already require very high perfor-
mance from the amplifier even at medium value and can easily oversteer it. This results in distor-
tions that may damage the loudspeaker.
In case of high volumes and/or highly turned up sound controls, check for distortions and turn
down the volume control or the sound controls immediately to prevent damage to the loudspea-
kers.
• Check again that all connections are correct.
• Turn the volume control (5) to the „MIN" (left) setting.
• Switch on the signal sources such as CD players, cassette decks etc.
• Turn the amplifier mains switch (1) on. The power indicator (2) will light up.
• With the input selection switch (8), select the desired input source (e.g. CD player).
• Turn the sound control (5) clockwise until you achieve the desired volume.
• You can change the sound with the sound controls (6) and (7).
• To turn the amplifier off, turn the volume control (5) back to „MIN" (left) and the turn the amplifier off with
the mains switch (1).
If you do not observe this order, the loudspeaker of the amplifier could be damaged.

9. Handling

• Never plug the power plug into a mains socket immediately after the device was taken from a cold to a
warm environment. The condensation water created thereby may damage the device.
Allow the device to reach room temperature before connecting it. Wait until the condensation water has
evaporated.
• Never pull the mains plug by pulling the cable from the socket. Always only use the thus provided grip
area.
• Remove the mains plug from the electrical outlet if the device is not in use for a longer period of time.
• For safety reasons always pull the mains plug from the socket during a thunderstorm.
• Do not listen to excessively loud music for long periods of time. This may damage your hearing.
33