BabyGo Snuggly Bedienungsanleitung Seite 15

Fig.4
Fig.5
Fig.6
Fig.8
3) Ensure that the two adjustable backrest
supports are attached to the seat support
frame. Assembly as shown in fig.4.
If not - follow fig.4. to do it. Ensure that it
was done properly and that pop pins are
locked.
4) Insert the seat frame front tube and
backrest tube into the seat support frame.
Ensure that the pop pins are locked.
5) Place the seat support frame assembled
in point.4. onto the swing control module
(fig.6.).
In order to disconnect swinging module
from seat support frame - release grey
button (fig.7.) and lift the seat frame at the
same time.
Fig.7
6) After proper assembly seat frame should
look like in the fig.8.
Electric Bouncer
15