Maintenance And Cleaning; Technical Data - Conrad 75 19 77 Bedienungsanleitung

• Hold the mounting arm to the appropriate mounting location.
• Mark the holes for drilling.
• Drill the mounting holes.
• Fasten the mounting base into place using appropriate installation material.
• Adjust the camera to the desired position. To do this, loosen the fastening screws
and after successfully adjusting the camera, tighten them again to secure the
position.
Do not point the camera directly towards a source of bright sunlight or
towards strong or indirect illumination as this may lead to overexposure and
a fuzzy picture.
Connection
To provide the suitable voltage supply, an optional power transformer is
required (recommended: 12 V/DC, 1,000 mA, plug polarity: inside=plus,
outside=minus). When acquiring this power transformer, check that the
polarity of the low-voltage plug of the power transformer corresponds to the
polarity marked on the low-voltage connector of the camera.
The wrong polarity can cause damage to the camera!
Proceed as follows to make the correct connections:
• Connect the BNC connector to the analogue video input of your display (e.g.
monitor).
• Connect the low voltage plug of your power transformer (not included in the delivery)
to the low voltage connector on the camera
• Plug the wall plug transformer into a domestic mains socket (230 V/AC 50 Hz).
• Turn your display device on and set the appropriate channel to enable the display
function.

Maintenance and Cleaning

Before cleaning the outside of the surveillance camera's casing, unplug it from the
mains.
To clean the outside of the camera, it is sufficient to use a dry, soft and clean cloth.
Do not use any aggressive cleaning agents. In case of heavy soiling, the cleaning
cloth can be slightly moistened.
Disposal
Electrical and electronic products do not belong in the household waste!
Please dispose of the device, when it is no longer of use, according to the
current statutory requirements.

Technical Data

Image sensor:
Camera lens:
Operating voltage:
Current consumption:
Recommended wall plug transformer:
TV lines horizontal:
Min. illumination level:
Detection area, horizontal:
Detection area, vertical:
IR LED range:
Number of IR LEDs:
Dimensions (Ø x D):
Weight:
Operating temperature range:
IP protection class:
8.5 mm (1/3") Sony CCD
25 mm
12 V/DC
max. 1,000 mA (with activated IR LEDs)
12V/DC, 1,000 mA
Plug polarity (inside=plus,
outside=minus)
420
0 Lux (IR ON)
approx. 14°
approx. 14°
up to 100 metres
6
approx. 120 x 128 mm
(without sun protection and base stand)
approx. 1,195 grams
(without sun protection and base stand)
-20°C to +50°C
IP65
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240
Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or
the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
© Copyright 2010 by Conrad Electronic SE.