Intended Use; Safety Information - Renkforce D-3000 Bedienungsanleitung

3. Intended use

The fog machine heats an appropriately suited fog liquid to evaporating point, thus creating a fog effect.
This product is only approved for connection to 230 V/50 Hz AC power via an earthed mains socket.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms, must be
avoided under all circumstances.
Any use other than that described above can damage the product and may involve additional risks such as
short circuit, fire, electric shock, etc.
The entire product must not be modified or converted, and the casing must not be opened.
Observe all safety information in these operating instructions!

4. Safety information

The warranty/guarantee will expire if damage is incurred resulting from non-compliance with
these operating instructions. We do not assume liability for any consequential damage.
Nor do we assume any liability for damage to property or personal injury caused by improper
use or failure to observe the safety instructions. In such cases the warranty/guarantee is void-
ed.
Dear customer, the following safety information is intended not only for the protection of the
device but also for the protection of your health. Please read the following items carefully:
• To ensure that the device is set up correctly, always read these operating instructions includ-
ing the safety instructions thoroughly and attentively before use.
• Check the device for damage before using it. If the device is damaged, do not operate it and
consult an expert or our service team.
• For safety reasons, any unauthorized conversions and/or modifications to the product are not
permitted.
• This device is a protection class I product. The voltage source must be a proper mains socket
(230 V/50 Hz) of the public mains with a protective ground contact.
• Never plug in or unplug the mains plug when your hands are wet.
• Make sure that the mains cable is not squeezed, bent, damaged by sharp edges or put under
mechanical stress. Avoid excessive thermal stress on the mains cable from extreme heat or
cold. Do not modify the mains cable. Otherwise the mains cable may be damaged. A damaged
mains cable can cause a deadly electric shock.
19