Renkforce D-3000 Bedienungsanleitung Seite 25

Man Vol Out
Setting the fog volume in TIMER mode
• Use the FUNCTION (3) button to select the menu item Man Vol Out.
• Set a value of 10% - 100% with the UP (4) and DOWN (5) buttons.
Attention: In the menu, you can also pick a value below 10%. However, there is the possibility/
danger that the fog machine will not work properly or interrupt operation since the heating ele-
ment is not operated within its operating parameters in this range.
If the setting "NONSTOP BURST" has been selected, there will be no fog emission in timer mode.
Interval Set
Setting the break length between the fog bursts in TIMER mode
• Use the FUNCTION (3) button to select the menu item Interval Set.
• Use the UP (4) and DOWN (5) buttons to set the desired value (10S - 900S) for the pause length.
Attention: Do not chose a setting below 10S. In timer mode, there is a risk that the pump will be
destroyed at a value below 10S.
Duration Set
Setting the fog burst time in TIMER mode
• Use the FUNCTION (3) button to select the menu item Duration Set.
• Use the UP (4) and DOWN (5) buttons to set the desired value (10S - 200S) for the fog burst length.
Attention: Do not chose a setting below 10S. In timer mode, there is a risk that the pump will be
destroyed at a value below 10S.
The set amount of fog in the menu item "Man Vol Out" influences the maximum continuous fog
output time to be reached (fog output without heating phase interruption). Example: If the amount
of fog 10% is selected, the maximum amount of fog output time of 200S can be selected. Here the
fog machine produces fog without interruption for 200S. If the amount of fog 100% is selected, a
maximum fogging duration of only 60S can be reached.
Volume OUT
Setting the fog volume for permanent mode
• Use the FUNCTION (3) button to select the menu item Volume OUT.
• Use the UP (4) and DOWN (5) buttons to set the desired value (1% - 100%) for the fog volume.
For permanent operation, the fog machine will occasionally interrupt fog bursts to heat up again.
If the setting "NONSTOP BURST" is selected, the fog machine runs during operation duration
with the "NONSTOP BURST"
button is pushed. The fog machine will automatically adjust the fog volume, so that the fog burst
does not have to be interrupted by a heating phase.
function. The machine will fog continually for approx. 5 min after the
25