Maintenance; A) Fuse; B) Cleaning - Renkforce D-3000 Bedienungsanleitung

9. Maintenance

Check the technical safety of the fog machine regularly, e.g. for damage to the connection cables or to
the casing.
If you have reason to believe that the device can no longer be operated safely, disconnect it immediately
and make sure it is not operated unintentionally.
It can be assumed that safe operation is no longer possible if:
• there is visible damage to the device, remote control or cables
• the device is longer working
• the device was stored under unfavourable conditions for an extended period of time
• the device has been subjected to heavy stress during transport.
Always observe the following warning notes before cleaning or servicing the device:
Live components may be exposed if covers are opened or parts are removed (unless this can be
done without tools).
Connection points may also be live.
Before reconciliation, maintenance, repair or replacement of parts or assemblies, the device
must be disconnected from all voltage sources if it has to be opened.
If servicing of or repairs on the opened device are necessary, such must be carried out by a
specialist who is familiar with the risks involved and with the relevant regulations.
Capacitors inside the device may still carry voltage even though they have been disconnected
from all power sources.

a) Fuse

The fog machine is equipped with a circuit breaker (2). A fuse change is therefore not required. Push the
reset button if the circuit breaker has tripped.

b) Cleaning

Disconnect the device from the power supply and leave it to cool down before cleaning.
The device is maintenance-free and you should therefore never open it. If you open it, the guarantee will
expire.
Only clean it with a soft, dry cloth or a brush only. Never use aggressive cleaning agents or chemical solu-
tions as the surface of the casing could be damaged.
The fog machine can be cleaned with a moist cloth on the outside. Never use aggressive cleaning agents,
chemical solutions or scouring agents as the paint coating could be damaged.
Avoid deposits and residue in the fog fluid channels by using a special fog machine cleaner. Observe the
instructions for cleaning liquid. The fog machine should be cleaned at least every 40 operating hours.
29