Product Care And Storage - Lupine Wilma R Bedienungsanleitung

7
Special Functions
Adjusting the low-battery warning LEDs:
Use this program to adjust the onset of the low-battery warning.
1.
Press and hold the button for until 4
release the button.

2.
The threshold can be selected as shown below.
Lamps backlight and remote:
Recover factory settings:
1.
Press and hold the button until 5 red
release the button.

2.
Disconnect the battery, and all factory settings will be restored.
4 8 Wilma
green LEDs light up.
red red
blinking
6.2 V 5.8 V
6.4 V 6.0 V
Factory setting
6.6 V 6.2 V
6.9 V 6.5 V
7.1 V 6.8 V
LEDs turn on.

Product care and storage

Plug contacts:
Normally the plug contacts are maintenance free. However, if you use your Wilma light in humid, salt-
air, environments, it's advisable to apply a thin layer of
often to prevent oxidation. Do NOT use terminal grease or contact spray.
Transport:
Important: Always keep the battery separate from the Wilma light,
amount of power used by the electronics will discharge the battery, and the lamp may switch on
accidently. Important! Moreover, the consequent uncontrolled heat buildup could cause a fire or
melt the adjacent plastic material. Could cause fire or
Storage:
During lengthy periods of non-use, fully charge the battery and store it in a cool, dry place, basement
or the like. The battery can be kept plugged into the charger if desired.
Opening the frontcap:
Open the light housing's front screw-on cover. Grasp the rear section of the lamp with one hand while
rotating the front section of the cover to the left (counterclockwise) with the other hand. Once you
have removed the cover, you will see the 4-array lens. Do not touch it.
Closing the frontcap:
Check to ensure that the O-ring on the rear section of the housing is correctly positioned.
The housing will only be waterproof if its O-ring is intact. After completing this inspection, carefully
screw down the housing cover. Important note: if the thread runs smooth, the cap is in the right
position. Otherwise please stop and screw back the cover and try again, otherwise you might
damage the thread.
Bluetooth module:
The housing of the Bluetooth module on the underside of the lamp head may
only be opened by Lupine or authorized distributors.
Lupine Dutch Grease to the contacts every so
because otherwise the small
death!
Wilma
8
49