Customizing Brightness Levels - Lupine Wilma R Bedienungsanleitung

4
Customizing the brightness levels
You have the option to setup to 4 brightness
1.
Press and hold the button until one
release the button

2.
The range of brightness levels you can select will
3.
Press the button at the brightness level you want.
the first power-on click is presented

4.
Upon releasing the button, the sequence
of brightness levels automatically
restarts, allowing you to set a second
level in the same manner as the first click
set-up. This process can be repeated up
to four times, but will stop when you quit
making further selections, thus allowing
your light to operate in 1-step, 2-step,
3-step,-or 4-step modes.
* Will not be signalised by status LED
4 2 Wilma
levels, in any sequence
green LED lights up.
begin automatically to cycle, as shown below.
0.3 W
brightness level
1.5 W
brightness level
3 W
brightness level
5 W
brightness level
7 W
brightness level
10 W
brightness level
14 W
brightness level
19 W
brightness level
23 W
brightness level
28 W
brightness level
SOS*
RVLR*
Alpine SOS*
Flash*
Default setting
Default setting:
1. brightness level 14 W
28 W
2. brightness level
3. brightness level 1.5 W
Recover factory settings:
1.
Press and hold the button for about 8 seconds, until 5
release the button

2.
Disconnect the battery, and all factory settings will be restored.
SOS:
SOS will continue until the battery is empty. Improper use of the SOS
signal is punishable by law.
RVLR:
This mode offers a slow flash mode.
Alpine SOS:
Alpine SOS will continue until the battery is empty.
signal is punishable by law.
Flash 15hz: (Disorientation)
This mode is extremely irritating and may by no means be misused.
App available:
All changes to the light can also be made by
the free Light Control App for IOS and Android.
With the App it is also possible to remote
control the light and the status monitor offers
additional informations.
red LEDs turn on.
Improper use of the SOS
Wilma
4
43