Read This Manual Before Using - Lupine Wilma R Bedienungsanleitung

Index
English

Read this manual before using

Mounting
Operation
BLuetooth
Customizing brightness levels
Micro Charger
Charger Wiesel
Special Functions
Product care and storage
Technical data
Troubleshooting
Miscellaneous
Notes
28 Wilma
29
30–34
35–39
40-41
42–43
44
45
46-48
49
50-51
52
53
54
Read this manual before using
Safety instructions:
Warning!
Avoid looking directly into the light emitted by the light or shining the light into your own eyes or the eyes of
another person. If the light accidentally shines into your eyes, close your eyes and move your head out of the light
beam.
Do not use any strongly focusing optical device to look at the light beam.
In cases where the light is used in a public or commercial setting, users should be provided with training concerning
the safety measures for laser light.
Re-charge you battery before you using the light.
Carry a spare light with you at all times, as the product can potentially fail unexpectedly at any time.
Automatic cutoff BLUETOOTH:
If the lamphead is connected to the battery, without switching the light on, the Bluetooth module will
automatically deactivate after 2 hours. You now can NOT turn on the light via the Bluetooth remote.
Either press the lampheads switch, or reconnect the battery to start the Bluetooth module or light.
Heat generation:
The housing of Wilma/ Wilma R may heat up; so make sure that you always keep the light at a safe distance to any
combustible or flammable materials. Could cause fire or death! However, quiescent operation (without cooling the
light housing via airflow or the like) is possible at any time and will not damage the product.
When the light is being used in a stationary state, the light will be dimmed after a few minutes to reduce the light's
temperature. Continuous operation at 28 watts is only possible with air flowing over the housing!
Important! Always disconnect the battery from the light at transport or storage!
Otherwise the small amount of power used by the electronics will discharge the battery, and the lamp may be
switched on accidentally.
Water resistance:
All Wilma/ Wilma R components are waterproof and can of course be used under extremely severe conditions.
The lamp complies with IP protection class 68 but is NOT a diving lamp and is NOT suitable for use under water.
1
Wilma 29