Installing The Filter Pump In The Container; Connecting The Aquamax Gravity Eco Pump To The Dn 110 Outlet; Connecting The Aquamax Gravity Eco Pump To The 2" Outlet - Oase ProfiClear Premium Gebrauchsanleitung

Fitting the DN 110 outlet
How to proceed:
4.
H
1. Fit the O ring onto the outlet.
2. Fit the outlet into the respective hole of the container wall from the outside.
Ensure that the raised marking is at the top and aligned in relation to the hole pattern.
−
3. Fasten the outlet from the inside with oval head screws.
Tighten all screws diagonally using the cordless screwdriver to ensure that the sealing ring is
−
uniformly applied. Further tighten the screws using a Phillips screwdriver.
4. If necessary: Close the outlet with the cover cap or connect further DN 110 pipes.
Fitting the 2" outlet
How to proceed:
5.
I
1. Push the flat seal onto the 2" connection.
2. Insert the 2" connection (long side first) from the inside into the hole.
3. Secure the 2" connection with the star grip nut.
4. Screw the 2" hose connector with flat seal and union nut from the inside onto the 2" connection.
5. Either screw the cover cap with flat seal or the 2" hose connector with flat seal and union nut from
the outside onto the 2" connection.
4.2

Installing the filter pump in the container

A maximum of two AquaMax Gravity Eco pumps can be installed in the container of an Individual
Module. For this purpose, each pump must be equipped with a rubber foot and a vibration damper.
4.2.1

Connecting the AquaMax Gravity Eco pump to the DN 110 outlet

To ensure optimum connection of an AquaMax Gravity Eco pump to a DN 110 outlet, use a pipe
connection consisting of the combination (DN 110): 45° connection bend - short straight pipe - 45°
connection bend - short straight pipe.
How to proceed:
6.
J
1. Prepare the filter pump according to the attendant operating manual with the connection adapter for
the DN 110 connection.
2. Align the pipe connection (consisting of two 45° connection bends and coupling sleeve) for
connecting the filter pump to the DN°110 connection and glue together. Then fasten it to the
connection adapter of the filter pump (secure using a pipe clip or glue). Place the filter pump in the
container.
3. Connect the pipe connection to the DN 110 connection in the same way.
4.2.2

Connecting the AquaMax Gravity Eco pump to the 2" outlet

How to proceed:
4.
K
1. Fit a 2" hose connector with flat seal inserted and union nut to the filter pump.
2. Fit a 2" hose connector with flat seal inserted and union nut from the inside to the 2" connection.
3. Connect the hose and secure both ends with hose clips.
19397-07-13_GA_ProfiClear_Premiu23 23
- GB -
23
25.07.2013 11:48:40