Cleaning And Maintaining The Lcd Monitor; Guarantee; Disposal - Waeco PerfectView M170L Montage- Und Bedienungsanleitung

PerfectView M170L
Note
I
You can reset the monitor to the factory settings for brightness, contrast, tint and
volume.
To do this, proceed as follows:
➤ Press the "MENU" button (3) five times.
➤ Press the "–" button (2), to reset the device to the factory settings.
➤ Press the "MENU" button (3) to exit setup mode.
9

Cleaning and maintaining the LCD monitor

Caution!
e
Remove the cable before cleaning the monitor to prevent short circuiting.
Caution
a
Do not use sharp or hard objects or cleaning agents for cleaning as these may
damage the device.
➤ Occasionally clean the device with a damp cloth.
10

Guarantee

The statutory warranty period applies. If the product is defective, please contact the man-
ufacturer's branch in your country (see the back of the instruction manual for the address-
es) or your retailer.
For repair and guarantee processing, please include the following documents when you
send in the device:
A copy of the receipt with purchasing date
A reason for the claim or description of the fault
11

Disposal

➤ Place the packaging material in the appropriate recycling waste bins wherever possi-
ble.
If you wish to finally dispose of the device, ask your local recycling centre or spe-
M
cialist dealer for details about how to do this in accordance with the applicable
disposal regulations.
Cleaning and maintaining the LCD monitor
37