Installing The Monitor - Waeco PerfectView M170L Montage- Und Bedienungsanleitung

PerfectView M170L
7.2

Installing the monitor

Caution!
a
Select the location of the monitor so that it cannot injure the passengers in the
vehicle under any circumstances (e. g. sudden braking, road traffic accidents).
Observe the following installation instructions:
Select an installation location that provides an unobstructed view of the monitor
(fig. 0, page 6 and fig. a, page 6).
Never install the monitor in area where your head could impact it or in the air bag de-
ployment path. This could cause injury if the airbag opens.
The monitor must not impair your vision when driving (fig. b, page 7).
The installation location should be flat.
Check that there is sufficient space underneath the installation location to attach the
washers and nuts.
Check beforehand that there is sufficient space on the other side for the drill head to
come out.
Bear in mind the weight of the monitor. Provide reinforcement if necessary (larger
washers or plates).
Ensure that you can lay the connection cable set to the monitor.
To perform the installation, proceed as follows (fig. e, page 9):
➤ Slide the monitor (1) onto the mounting plate of the monitor bracket (2) and secure it
on the monitor bracket with the knurled screw (3).
➤ Position the monitor and the attached monitor bracket for testing.
➤ Mark the outlines of the corners of the monitor bracket (2) on the dashboard.
➤ Unscrew the monitor from the monitor holder.
➤ Hold the monitor bracket within the outlines marked beforehand and mark four different
drilling points.
➤ Drill Ø 2 mm holes at the points you have just marked.
➤ Screw on the monitor bracket with the 4 x 20 mm self-tapping screws.
➤ Slide the monitor (1) onto the mounting plate of the monitor bracket (2) and secure it
on the monitor bracket with the knurled screw (3).
Note
I
You can now adjust the angle of inclination. To do this, loosen the knurled screw
(4) and tilt the monitor to the desired position. Tighten the knurled screw (4).
Mounting the monitor
33