Hartan Xperia GTX Bedienungsanleitung Seite 10

WARNING!
When opening out and folding down the frame and when adjusting the back-rest, pinch-points
may be caused in which fingers etc. can be trapped unless care is exercised. Ensure that your child has plenty
of clearance space.
unfolding the pram
By pushing the lock buttons 4, unfold the upper section to bring the handle in horizontal position. Pull handle
1 upwards until handle catch 2 has engag ed.
are locked.
Folding the pram
Important: Swing the handlebar 1 that the white symbols on the twist grip 3 are visible from above. Turn rota-
ting lock 3 inwards until the handle unlocks, then push the handle down. Then press retaining buttons 4 and
fold the top part of the handle downwards.
Reversible handlebar
To reverse the handlebar, turn the twist grips 3a in the direction of the arrow.
the handlebar, take care that no movable parts jam the baby's limbs, or fingers, etc. Finally, make sure the
hand lebar has reengaged properly, which is indicated by a click sound.
Height adjustment of handlebar
Press the two handle-folding lock buttons 4 to bring the upper section of the handlebar 1 in the desired posi-
tion.
Removing the wheels
Release the parking brake 7. To remove or replace the wheels, press button 5. If replacing the wheel, make
sure that it is correctly latched into place.
lock-type-swivel wheels
To fix the swivelling wheel turn the caps 6 until the red spot appears;
the wheel locks itself in place automativcally as soon as it faces for-
wards. Turn the cap 6 so that the green point is visible to release the
swivel lock. To remove, press the button in the centre of the cap 6 and
withdraw the wheel from its seating. To fix the wheel in place, push the
wheel with its fixing pin into the seating until it audibly clicks into place.
Parking brake
To lock the wheels, depress the red securing button situated at the
brake lever 7 and swing the lever down. The two toothed brake-crown
wheels engage, which is indicated by a click sound. To release the
brake, swing the lever up until it snaps into place. Having parked the
pram, try to push it to check the brake.
WARNING!
Make sure the brake is always closed when placing
the baby in the carriage or taking it out of it.
Adjusting the parking brake
After prolonged use, the wheels may cause a rattling noise. You can
eliminate the problem by readjusting the setting screw 7a situated at
the brake housing.
Adjust the handbrake (optional)
Readjust the hand brake by means of the cable adjusting barrel 9
(above). A different brake effect on the two rear wheels can be
corrected by means of the cable adjusting barrel 9a (below).
WARNING!
Before using the pram, make sure all catches
Instructions
WARNING!
When reversing
7
7a
9