Control Connection For Remote; Connecting The Power Supply - Renkforce A-1000 Bedienungsanleitung

Control connection for remote

Should further devices be connected to the Renkforce HiFi series, these can be controlled by remote via the system
panel.
For this, the control sockets of the individual devices must be connected to the control sockets of the amplifier.
Connection leads come together with the individual devices.
• Connect the control socket of your equalitzer with the control socket REMOTE SYSTEM EQ at the rear of the
amplifier.
• Connect the control socket of your tape deck with the control socket REMOTE SYSTEM TAPE at the rear of the
amplifier.
• Connect the control socket of your radio with the control socket REMOTE SYSTEM TUNER at the rear of the
amplifier.
• Connect the control socket of your CD player with the control socket REMOTE SYSTEM CD at the rear of the
amplifier.

Connecting the power supply

Before connecting the amplifier to the mains power supply, make sure that the POWER switch
(1) is off (position „OFF") and that the VOLUME control (5) is turned right down (all the way to
the left).
The POWER (1) switch does not entirely disconnect the device from the electricity supply. In
order to completely separate the device from the electricity net, you have to pull the mains plug
out of the wall socket.
• Connect the mains plug of the amplifier's mains cable to a socket (230V~/50Hz) linked to the public power supply
network.
34
Operating Instructions

English