Installation; Inserting The Batteries Into The Remote Control - Renkforce T21 Bedienungsanleitung

8. Installation

When selecting the setup location, take the room layout into consideration (e.g. location of the nearest socket).
Avoid proximity to direct sunlight, vibrations, dust, hot and cold temperatures and dampness. The device must not be
placed next to powerful transformers or motors.
The device must be operated on a stable, level surface. There must be enough space around the device for
air to circulate, otherwise heat will not dissipate properly. Only place the device on smooth, level surfaces
(not carpets or other uneven surfaces). Do not cover the ventilation slots.
Failure to observe these instructions may damage the device.
Do not drill holes or screw extra screws into the device. This will damage the interior components and may
cause a fatal electric shock.
Ensure that the device is placed on a stable surface to prevent it from falling off and causing injury.
The feet may leave marks on certain types of furniture.
Do not place the device on top of valuable furniture without appropriate protection.

9. Inserting the batteries into the remote control

The amplifier can be controlled wirelessly using the remote control.
Keep batteries out of the reach of children.
Batteries must not be placed in household waste.
Always ensure that batteries are inserted in the correct polarity.
Remove the batteries when you do not plan to use the remote control for a prolonged period.
Do not leave batteries lying around, as they constitute a choking hazard for children and pets. If swallowed,
seek immediate medical advice.
Batteries must not be short-circuited or thrown into open flames. Do not attempt to recharge non-recharge-
able batteries, as this may cause an explosion.
When handling leaking or damaged batteries, always use suitable protective gloves to avoid burning your
skin.
• Slide the battery compartment cover off the remote control.
• Insert two new 1.5 V AAA batteries into the battery compartment. Pay attention to the polarity markings on the
bottom of the compartment.
• Slide the cover back onto the remote control.
• Replace the batteries when the range of the remote control deteriorates or the remote control ceases to function
properly.
• Use alkaline batteries to ensure a longer battery life.
• Never mix old and new batteries or batteries from different manufacturers. Do not mix non-rechargeable batteries
with rechargeable batteries.
24