Programming Via The Learning Function - Renkforce 34 28 16 Bedienungsanleitung

• Press the OK key to store the alterations
or the EXIT key to cancel the alterations.

You press the EXIT key at any time to return to normal operation without
saving the changes made.

Programming via the learning function

This feature is used to program the infrared commands of devices which are not listed
in the code list or have not been recognised by the code search run.
Special keys can be programmed with this for devices which have not been covered
by the codes.
With this feature, all keys of the operating key area (4) and also the device selection
keys (5) can be programmed.
• Direct the infrared transmitter diode of the
original remote control at a distance of
approx. 5-10 cm to the infrared receiver
(6) . Avoid placing the devices on reflecting
surfaces and do not attempt to programme
the remote control in environments with a
high light intensity.
• Press the CODE key for approx. 4 seconds.
47