Sygonix EX 1 Bedienungsanleitung Seite 49

If "0" has been entered for both limits, the function is deactivated.
If both limits are programmed (e.g. 1000 W and 2 A), the alarm is
tripped when exceeding the lower value (to remain with the above ex-
ample -> at 2 A/230 V/AC = 460 W).
• If you have set the CO
e), you can continue with the next step right away.
Otherwise, the setting mode must be started by pushing the button "SET"
(3) for approx. 3 seconds. The upper left of the display shows "SET" and the
upper display line shows "24 Hr".
Briefly push the button "
load, see next step.
• The top of the display shows "OVERLOAD"; the limit for the overload can now
be set.
• Briefly push the button "SET" (3); "W" will flash in the display.
• Use the button "
flashes) and current ("A" flashes).
• Briefly push the button "SET"; (3); the first digit of the limit will flash.
• Change the figures for the respective flashing input item with the button "
" (6) or " " (5).
Confirm the setting with the button "SET" (3) to switch to the next input digit.
After confirmation of the last input digit, the display will stop flashing.
If desired, the value can now be changed/set again, see above.
• Briefly push the button "
g).
To leave setting mode, keep the button "SET" (3) pushed for 3 seconds (or do
not push any button for 1 minute).
emission before setting the limit for overload (see
2
" (5) 4x to get to the setting of the limit for over-
" (6) or " " (5) to switch between the limit for power ("W"
" (5) to get to deletion mode, see the next section
49