E) Settings For Ghg/Co -Emission - Sygonix EX 1 Bedienungsanleitung

Confirm the setting with the button "SET" (3) to switch to the next input digit.
After confirmation of the last input digit, the display will stop flashing and the
first value entered for standby power intake ("STANDBY POWER LEVEL") will
appear.
If desired, the value can now be changed/set again, see above.
• Briefly push the button "
= "Greenhouse gas"), see next section e).
To leave setting mode, keep the button "SET" (3) pushed for 3 seconds (or do
not push any button for 1 minute).
e) Settings for GHG/CO
Here, you can enter the CO
to your power rate (e.g. 480 g/kWh) can be learned from the website of your
power provider, or possibly also the contractual documents.
Our advice:
If you have a power rate with 100% green power, putting in 0.000 kg
CO /kWh is, of course, hardly sensible.
2
Here, you can enter the CO
tariff. This way, the meter shows how much CO
environment by preferring a green power provider as power provider.
Depending on the power intake, the meter shows the respective CO
sion that arises in operation of the connected consumer.
" (5) to get to the setting for the CO
-Emission
2
-emission per kWh. The respective value applicable
2
-emission value for a conventional power
2
-value ("GHG"
2
your are sparing the
2
emis-
2
47