F) Alarm At Overload - Sygonix EX 1 Bedienungsanleitung

• If you have set the standby power intake before setting the CO
d), you can continue with the next step right away.
Otherwise, the setting mode must be started by pushing the button "SET"
(3) for approx. 3 seconds. The upper left of the display shows "SET" and the
upper display line shows "24 Hr".
• Briefly push the button "
see next step.
• The lower left of the display shows "GHG/CO
entered.
• Briefly push the button "SET"; (3); the first digit of the CO
Change the figures for the respective flashing input item with the button "
" (6) or " " (5).
Confirm the setting with the button "SET" (3) to switch to the next input digit.
After confirmation of the last input digit, the display will stop flashing.
If desired, the value can now be changed/set again, see above.
• Briefly push the button "
see next section f).
To leave setting mode, keep the button "SET" (3) pushed for 3 seconds (or do
not push any button for 1 minute).

f) Alarm at Overload

The meter emits an alarm sound when exceeding an adjustable limit and the
display shows "OVERLOAD".
This function can not only be used to protect the meter or the connected con-
sumer, but also to signal when the consumer exceeds the specified limit in
regular operation. You do not need to monitor the display all the time.
A value for power (W) and current (A) can be set as limit.
48
The home technology brand for the entire house. More information at www.sygonix.com
" (5) 3x to get to the setting of the CO
", the CO
2
" (5) to get to the settings for alarm at overload,
-emission (see
2
emission,
2
emission can now be
2
emission will flash.
2