Ordering Replacement Parts; Storage; Disposal - EINHELL BG-WW 1136 Originalbetriebsanleitung

Anleitung_BG_WW_1136_SPK7:_
GB
11.1 Servicing
If the equipment becomes clogged, connect the
discharge line to the water line and disconnect
the intake line. Open the water line. Switch on
the equipment several times for approx.
two seconds. This should resolve the majority of
clog-related problems.
The pressure vessel is equipped with a flexible
water bag and an airspace with a max. pressure
of approx. 1.5 bar. When water is pumped into
the water bag, the bag will extend and increase
the pressure in the airspace until the cut-out
pressure is reached. If this air pressure is too
low, it must be increased. To do so, screw off the
valve cover (Fig. 3/Item 11) on the vessel and
use a tire pressure gauge to replace the missing
pressure through the valve (Item 12). Then
screw the valve cover back on.
Important:
Be sure to completely empty the water bag first
using the water drain screw (8).
11.2 Cleaning the coarse filter insert
Clean the coarse filter insert at regular intervals,
and replace it if necessary.
Remove the coarse filter screw (6) and coarse
filter (Figure 2).
Do not use abrasive cleaning agents or petrol to
clean the coarse filter.
Clean the coarse filter by tapping it on a flat
surface. In cases of stubborn dirt first clean with
soapy water, then rinse with clear water and air-
dry.
Assemble in reverse order.

11.3 Ordering replacement parts:

Please provide the following information on all orders
for spare parts:
Model/type of the equipment
Article number of the equipment
ID number of the equipment
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info

12. Storage

Store the equipment and accessories out of
childrenʼs reach in a dark and dry place at above
freezing temperature. The ideal storage temperature
is between 5 and 30 °C. Store the electric tool in its
original packaging.
14
21.07.2010 8:16 Uhr Seite 14
13. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.