Answering Machine - switel DET 3371 Bedienungsanleitung

Registering a handset
☞
Five handsets can be registered to a base station. The handsets deli-
vered with your telephone are already registered. To register a "foreign"
handset please refer to it's user manual.
First of all disconnect the base station from the mains and re-connect
it. After this the base station will be in registration mode for 3 minutes.
... press and hold for approx. 3 seconds until
... press and hold for approx. 3 seconds.
Enter a number for the base station (1 ... 5) to subscribe to.
Enter the PIN for the base station (default setting for DE 337x base
station "0 0 0 0").
If the handset is registered the display will show HS and the handset's
internal telephone number.
Deleting a handset
☞
You can delete a handset from a base to allow another handset to be
registered. Note: you can only remove other handset in your system but
you are not able to remove the handset you are using.
... press and hold
... press and hold for approx. 3 seconds.
Enter the PIN for the base station (default setting for DE 337x base
station "0 0 0 0").
Enter the internal telephone number (1...5) of the handset you want to
remove.
The handset will go back to standby is the removal is successfully.
Ringtone melody (handset)
... press and hold for approx. 3 seconds. The current melody sounds.
... select the desired melody.
Press to confirm the setting.
Ringtone volume (handset)
... press briefly. The handset will ring in the current volume.
... select the desired volume. When the volume is "0" (ringer off),
appears in the display.
Press to confirm the setting.
and flash.
for approx. 3 seconds.
Setting the flash time
☞
You can set the flash time to 100 ms (usually for special services of
your telephone provider/delivery state) or 300 ms (e. g. for a telephone
exchange). In case of questions please contact your telephone provider or
the system administator of your PBX.
... press and hold for approx. 3 seconds. S (100 ms) or L (300 ms)
appears in the display. For switching the flash time press and hold
again for approx. 3 seconds.
Setting the dial mode (tone / pulse)
☞
You can switch the dial mode. In most situations the TONE option
should be selected.
... press and hold for approx. 3 seconds. t (tone) or P (pulse) appears
in the display. For switching the dial mode press and hold
for approx. 3 seconds.

6 Answering Machine

The answering machine is operated via the base station.
Switching the answering machine on/off
... press. The answering machine is switched on.
... press again. The answering machine is switched off.
Setting the answering machine language
The language used by the answering machine can be set to one of the fol-
lowing languages: German, English, French.
... press and hold for approx. 10 seconds to set the required language.
An acoustic confirmation signal is issued and the language abbreviati-
on appears in the base station display.
Answering mode
You can select between "answer with message recording" and "answer
only" modes.
☞
The answering machine is provided with pre−recorded outgoing
messages at the factory. These outgoing messages are played if you do
not record your own outgoing messages.
again
GB
5