G) Bar Graph; Settings; A) Emission Level; Temperature Unit - VOLTCRAFT IR 650-16D Bedienungsanleitung

g) Bar graph

• The bar graph can be used to graphically display the current measured value in relation to
the MIN/MAX values. The left end represents the MIN value of the current measurement, the
right end the MAX value.
• Example: The MIN value is 0 °C and the MAX value +100 °C. The current measurement is
+50 °C. In this case the bar graph deflects to the middle of the display.

11. Settings

a) Emission level

The measuring device allows setting the emission ratio. Thus, different materials and surfaces
can be measured with exact results.
• Hold the MODE button for approx. 1 second to access the setup menu. The symbol for the
emission level flashes.
• Press the ▲ or ▼ button to change the value. Press and hold the button for fast setting.
• Press the measuring button to confirm your input or press the MODE button to proceed to
the next setting.
• When the device is switched off, the set value is retained.
Following the technical data you will find a table with typical materials and their
emission level.
b) Temperature unit
• Hold the MODE button for approx. 1 second to access the setup menu.
• Press the MODE until measuring unit flashes on the display.
• Use ▲ and ▼ to select the desired measuring unit.
• Press the measuring button to confirm your input or press the MODE button to proceed to
the next setting.
• When the device is switched off, the set value is retained.
32