Changing The Batteries - Sygonix 1593775 Bedienungsanleitung

OFF - the system is switched
Press the OK button to confirm the setting.
g) Changing the batteries
The battery symbol (4) appears on the
display when the batteries are nearly empty.
Replace the batteries when this occurs.
All settings will be lost when the
power supply is interrupted.
The settings are also lost when
the batteries are replaced. After
replacing the batteries, you can
sync the room temperature controller (item no. 1593776) with the
"Sygonix RT100" app and restore the settings.
You should also replace the batteries when the display gets brighter/the contrast
decreases or when the time stops.
• To replace the batteries, loosen the front part of the temperature controller
with the switching circuit and the display (gently loosen the clips on the wall-
mounted unit). The clips are located in the middle of the unit on the left and
right-hand sides. Press underneath the clips and pull the front part of the
room temperature controller.
off
ON - the system stays
switched on
61