Connection Of A Matching Endoscope Camera; Switching The Device On/Off - VOLTCRAFT BS-1000 Bedienungsanleitung

Connection of a Matching Endoscope Camera

For a matching endoscope camera, see the chapter on matching accessories.

Switching the Device On/Off

Keep the button
After the start-up-screen, the battery charging state and the SD card capacity is briefly displayed on the
screen.
Charge the endoscope when the battery level is low.
A camera live image is displayed on the screen.
The endoscope is now in preview mode.
28
pressed for 3 seconds to switch the endoscope on or off.
1. Connect a compatible camera to the
socket. Observe correct alignment; the
hollow part on the plug (at the endosco-
pe camera) should fit over the protruding
part on the socket (basic device). Make
sure not to break off the pins.
2. Turn the metal screw lock clockwise to
fasten the camera.
3. Loosen the camera by turning the metal
lock counter-clockwise.