Arm/ Disarm Voice Prompt; Voice Prompt For All Settings; Tamper Alarm Setting; Imei Checking - mt vision AS-200 Bedienungsanleitung

Function settings

26. Arm/ Disarm Voice Prompt

This product has this function: when you arm/ disarm it, it will give voice prompt
"system armed/ disarmed". You can deactivate it if you do not need.
In setting status, first input 83, then 0/1 and finally press # to confirm. The main unit
will make a long beep and voice prompts:setting completed, please enter instruc-
tion.
Operating method: 83 a 0/1 a #
1: activate voice prompt for arm/ disarm (factory default)
0: deactivate voice prompt for arm/ disarm
For example: Set arm/disarm voice prompt OFF
Operating method: 83 a 0 a #

27. Voice Prompt for All Settings

For all above settings, you could hear the voice prompt such as "setting completed,
please enter instruction", "delete completed". You can deactivate the voice if you do
not need them. In setting status, first input 84, then 0/1 and finally press # to
confirm. The main unit will make a long beep and voice prompts: setting completed,
please enter instruction.
Operating method: 84 a 0/1 a #
1: activate voice prompt for all operations (factory default)
0: deactivate voice prompt
For example: Set voice prompt OFF
Operating method: 84 a 0 a #
ENGLISH
18
Function settings

28. Tamper Alarm Setting

There is a tamper alarm button at the back side of the panel. If you install the panel
with the bracket (included in the standard pack), this button will be pressed down.
When someone is trying to disassemble the panel, the button will be loosen once
the bracket is taken off and the system will make alarm at the same time.
In setting status, first input 87, then press 0/1 and finally press # to confirm. The
main unit will make a long beep and voice prompts: setting completed.
Operating method: 87 a 0/1 a #
0: Tamper alarm OFF (factory default)
1: Tamper alarm ON
For example: Set Tamper alarm ON
Operating method: 87 a 1 a #
Note: The alarm SMS is "zone 99 emergency alarm".

29. IMEI Checking

In setting status, first input 88 and then press # to confirm. The 15-digit IMEI code
will be displayed separately in 4 pages (2 seconds per page) on the screen.

30. SMS Notification for Power Failure/ Recovery

In Out Arm status, if the main panel is powered off, the built-in battery will sup-
ply power, and main unit will send SMS (power charger off) to all the three preset
SMS-receiving numbers.
In Out Arm status, if the main panel recovers power, it will send SMS (power charger
on) to all the three SMS-receiving numbers. While in Disarm or Home Arm status, it
does not have this function.
Note:
The alarm SMS is zone 99
emergency alarm".
ENGLISH
19