Delete Remote Controller; Coding Of Defense Zone; Delete Defense Zone; Change Password - mt vision AS-200 Bedienungsanleitung

Function settings
A indicates: 1~8 remote controllers number. You can add
maximum 8 remote controllers.

6. Delete Remote Controller

The remote controller can't control the main unit after it's deleted. In setup state, use
keypad to input 21, then input the remote controller number 1-8, and then press # to
confirm. The main unit emits a long beep and the Signal indicator flickers once. You
will hear a voice prompt "delete completed".
Operating method: 21 a A a #
A indicates: 1~8 remote controllers number.

7. Coding of Defense Zone

Wireless detectors have to be coded to the main unit in order to trigger it alarm. The
wireless PIR and door sensor in the standard package have been coded. In setup
state, use keypad to input [23], input the defense zone number you want to code
[01~99], and then input [#] to confirm. The main unit emits a long beep and the
corresponding defense zone is displayed on the screen. You will hear a voice prompt
"detector coding". Then trigger a wireless detector to emit a wireless signal; after
receiving the signal, the main unit makes a long beep, and you will hear "coding
completed", the [ ] indicator goes out at the same time.
Operating method: 23 a XX a #
XX indicates: 01~99 defense zones number

8. Delete Defense Zone

The wireless detector can't control the main unit after it's deleted. In setup state, use
keypad to input 24, then input the defense zone number you want to delete 01~99,
and then input # to confirm. The main unit emits a long beep and the defense zone
indicator flickers once. You will hear a voice prompt "delete completed".
Operating method: 24 a XX a #
XX indicates: 01~99 defense zones number
ENGLISH
08
Function settings

9. Change Password

Change Operation Password.

Operation password is the password used
to disarm or remote control. (Default: 1234)
In setup status, use keypad to input 30, then input the 4-digit new password, and
then press # to confirm. The main unit will make a long beep and you will hear a
voice prompt "setting completed".
Operating method: 30 a XXXX a #
XXXX indicates: the new 4-digit password
For example: change the system password to 1012
Operating method: 30 a 1012 a #

Change Program Password.

Program password is the password you should input
in order to setup the system. (Default: 8888)
In setup status, use keypad to input 31, then input the 4-digit new password, and
then press # to confirm. The main unit will make a long beep and you will hear a
voice prompt "setting completed".
Operating method: 31 a XXXX a #
XXXX indicates: the new 4-digit password
For example: change the system password to 2846
Operating method: 31 a 2846 a #
Note:
The operation password and the programming password can not be set as the
same number.
ENGLISH
09