Replacing The Power Cable - EINHELL TE-XC 110/1 Originalbetriebsanleitung

held circular saw!
6.2 Using the universal hand-held circular
saw
•
Adjust the cutting depth and the parallel stop
(see section 5.1 and 5.3)
•
Make sure that the On/Off switch (2) is not
depressed. Only then should you insert the
power plug into a suitable socket outlet.
•
Do not switch on the universal hand-held
circular saw until you have fitted a saw blade /
cutting wheel.
•
Place the saw foot flat on the workpiece you
want to saw. The saw blade must not be in
contact with the workpiece.
•
Now hold the universal hand-held circular
saw firmly with both hands.
6.3 Switching On/Off (Fig. 5)
To switch on:
Press the locking button (3) and the On/Off switch
(2) at the same time.
•
Allow the saw blade to accelerate until it
reaches full speed. Then slowly move the saw
blade along the cutting line. Exert only gentle
pressure on the saw blade as you do so.
Danger! Make sure that you do not cover
or block the ventilation openings while you
are working.
Notice! Carry out a trial cut in a piece of
waste wood.
To switch off :
Release the On/Off switch
•
When you let go of the handle, the machine
will shut down automatically. It is impossible
therefore for the saw to run unintentionally.
•
After you have switched off the saw, do not
slow down the saw blade by applying pressu-
re to its side.
•
Important: Do not put down the machine until
the saw blade / cutting wheel has stopped
completely.
6.4 Changing the saw blade / cutting wheel
(Fig. 1/6-8)
Danger! Always pull out the power plug
before doing any work on the circular saw!
Anleitung_TE_XC_110_1_SPK1.indb 20 Anleitung_TE_XC_110_1_SPK1.indb 20
GB
Use only saw blades which comply with standard
EN 847-1 and are of the same type as the saw
blade supplied with this universal hand-held cir-
cular saw. Ask your dealer for advice.
Use only diamond-tipped cutting wheels which
comply with standard EN 13236 and are of the
same type as the cutting wheel supplied with this
universal hand-held circular saw.
Ask your dealer for advice.
Do not use grinding wheels!
To change the saw blade / cutting wheel, use the
Allen key (5) supplied with the machine. The Allen
key (5) is kept in the housing. Pull the Allen key (5)
out of the housing (see Fig. 6) when you need it.
Important: For safety reasons, the hand-held cir-
cular saw must not be operated with the Allen key
(5) inserted.
•
Push back and secure the moving swing
guard hood (16) using the lever for the swing
guard hood (15).
•
Press the spindle lock (7).
•
Use the saw blade key (5) to undo the screw
holding the saw blade (18).
•
Remove the flange (19) and the saw blade /
cutting wheel (12) in downwards direction.
•
Clean the flange and insert a new saw blade
/ cutting wheel. Pay attention to the running
direction (see arrow on the guard hood and
saw blade / cutting wheel).
•
Tighten the screw to secure the saw blade
(18) and check that the blade runs true.
•
Before you press the On/Off switch, make
sure that the saw blade / cutting wheel is cor-
rectly fitted, that moving parts run smoothly,
and that the clamping screws are tightened
securely.

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
- 20 -
08.07.14 09:46 08.07.14 09:46