Electrolux EHL6740XOK Benutzerhandbuch Seite 14

14 www.electrolux.com
Problem
Residual heat indicator
does not come on.
Automatic Heat Up function
does not operate.
The heat setting changes
between two levels.
The sensor fields become
hot.
There is no signal when you
touch the panel sensor
fields.
comes on.
comes on.
comes on.
and a number come on. There is an error in the hob. Disconnect the hob from
Possible cause
The zone is not hot be-
cause it operated only for a
short time.
The zone is hot.
The highest heat setting is
set.
Power management func-
tion operates.
The cookware is too large
or you put it too near to the
controls.
The signals are deactivated. Activate the signals.
Automatic Switch Off oper-
ates.
The Child Safety Device or
the Lock function operates.
There is no cookware on
the zone.
The cookware is incorrect.
The diameter of the bottom
of the cookware is too small
for the zone.
The cookware does not
cover the cross / square.
Remedy
If the zone operated suffi-
ciently long to be hot,
speak to an Authorised
Service Centre.
Let the zone become suffi-
ciently cool.
The highest heat setting has
the same power as the
function.
Refer to "Daily use" chapter.
Put large cookware on the
rear zones if possible.
Refer to "Daily use" chapter.
Deactivate the hob and ac-
tivate it again.
Refer to "Daily use" chapter.
Put cookware on the zone.
Use the correct cookware.
Refer to "Hints and tips"
chapter.
Use cookware with correct
dimensions.
Refer to "Technical informa-
tion" chapter.
Cover the cross / square
fully.
the electrical supply for
some time. Disconnect the
fuse from the electrical sys-
tem of the house. Connect
it again. If comes on
again, speak to an Author-
ised Service Centre.