Silvercrest SMZS 260 E3 Bedienungsanleitung Seite 8

__RP93441_B6.book Seite 6 Montag, 12. August 2013 3:26 15
• Rinse or wash the food.
• Cut the food into small cubes (approx.
2-3 cm edge length).
• Remove the outer shell from nuts. The inner
shell can be used if so desired, e.g. with al-
monds.
• Free herbs from their stems.
• Separate the bones from meat and re-
move sinews and skin.
Processing table
Recom-
Ingredients mended
quantity
Onions
100 g
(quartered)
Garlic
(whole 100 g
cloves)
Walnuts 50 g
Almonds 50 g
Cheese
(e.g. Gouda, 100 g
cold)
Salami 130 g
Diced lean
beef
(approx. 250 g
2|cm edge
length)
Carrots 100 g
Dried fruit 130 g
Ice cubes 100 g
6
GB
NOTE: The processing times and speeds
specified here are guidelines.
• Depending on the quantities and consist-
ency of the foods, the actual values may
differ.
• Repeatedly check the results, depending
on how small you want to chop the
food.
• Work using short pulses (1|pulse: press
for approx. 1|second).
Recommended
processing time
Assembling the device
/ speed
CAUTION: Depending on the hardness
Pulse/
TURBO
and consistency of the food, do not fill the
vessel 7 up to the maximum level, as this can
cause the blade insert 6 to become blocked.
Pulse/
TURBO
Pay attention here to the guideline values for
various foods in the "Processing table" sec-
2 x 8 sec.
tion.
TURBO
1 x 10 sec.
1. Place the vessel 7 on the vessel cover 9.
(coarse)
2. Place the blade insert 6 on the spin-
1 x 30 sec. (fine)
dle|8 in the vessel.
TURBO
3. Place the prepared food into the ves-
sel|7.
4 x 15 sec.
4. Figure B: Place the working cover 4
TURBO
onto the vessel 7 in such a way that the
two small tabs on the working cover fit
3 x 5 sec.
into the grooves in the vessel and rotate
TURBO
the working cover clockwise until it
clicks into place.
3 x 12 sec.
5. Place the motor block 3 into the upper
TURBO
edge of the working cover 4.
NOTE: The motor block does not fit
onto the working cover entirely straight
3 x 5 sec.
on the right-hand side.
normal
6. Insert the mains plug 2 into a wall sock-
4 x 15 sec.
et corresponding to the technical data.
TURBO
Pulse/
TURBO