Oase MIDI Floating Fountain LM 230 V, 1.1 kW Gebrauchsanleitung Seite 15

Installation
Installation of the MIDI Floating Fountain LM (M-O)
When installing the unit, take into account the 'water' picture created by the individual nozzle. Avoid objects outside of
the pond to be reached by the water. This applies in particular to electrical installations (M).
The unit floats on the water. Adhere to the minimum water depth. To keep it in position, the enclosed wire cables are
fastened to the unit and either to the bank or to the pond bottom.
Anchoring the unit at the bank (N): Shorten the three wire cables to the desired length. Form loops at the cable ends
(28) and fasten with the cable clamps (29). Hook the cables into the eyebolts (32) at the float body by means of snap
hooks (27). Knock the three tent pegs (30) into the bank ground. Important: Adhere to the specified bracing angles (33)
to prevent the unit from moving. Set the unit in the water and hook the cables to the tent pegs (30) using the snap
hooks (27). Attention: Pull relieve the connection cable (31) and protect the power plug from moisture!
Anchoring the unit to the pond bottom (O): Shorten the three wire cables to the desired length. Form loops at the cable
ends (28) and fasten with the cable clamps (29). Hook the cables into the eyebolts (32) at the float body by means of
snap hooks (27). For anchoring to the pond bottom, screw the enclosed threaded hooks (34) including the dowel, for
instance, into three sufficiently heavy stones. Hook three cables with snap hooks (27) in the threaded hooks (34), lower
the stones to the bottom of the pond and set the unit on the water. Attention: Pull relieve the connection cable (31)
and protect the power plug from moisture!
Installation of the Control Box (35) / Motor (overload) protection switch (36) (M, P)
Install the control box / motor (overload) protection switch at a minimum distance of 2 m from the pond. Fit the control
box such that the connection cables hang down. The control box / motor (overload) protection switch meet protection
type IP 42. For this reason, fit a protective cover over the control box / motor (overload) protection switch to prevent the
ingress of moisture, if installed outside.
Start-up
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures: Isolate the unit prior to reaching into the water and carrying out any work on the unit.
Secure the unit from being switched on inadvertantly.
Switching on / Switching off (Q)
Note: Either a shock-proof plug (37) or a CEE plug (39) is fitted to the power connection cable of the unit.
Switching on:
 Plug the shock-proof plug (37) of the 1.1 kW unit (230 V) in the shock-proof socket. The unit switches on automati-
cally when power connection is established.
 For the 2.2 kW and the 4 kW unit (400 V), plug the CEE plug (39) into the CEE socket and press the green switch
(41) at the motor (overload) protection switch (36).
Switching off: Pull the shock-proof plug (37) / CEE plug (39).
The control box (35) and the motor (overload) protection switch (36) are intended to protect the motor. The pump will
be switched off in the case of an overload.
Functions of the button or the switches:
 Button (38): Press the button to restart the motor.
 Red switch (40): Press the switch to trigger the motor (overload) protection switch. The motor will switch off.
 Green switch (41): Press the switch to restart the motor.
Also read the section "Remedy of faults".
- EN -
15