Aim TSX-P Series Bedienungsanleitung Seite 31

∗PRE <nrf>
∗PRE?
∗RCL <nrf>
∗RST
∗SRE <nrf>
∗SRE?
∗STB?
SAV<nrf>
∗TST?
∗WAI
Other commands
V <nrf>
VV <nrf>
I <nrf>
OVP <nrf>
V?
I?
OVP?
VO?
IO?
DECI
DECV
DECVV
DELTAI <nrf>
DELTAV <nrf>
DELTAI?
DELTAV?
INCI
INCV
INCVV
POWER?
OP <nrf>
DAMPING <nrf>
LSR?
LSE <nrf>
LSE?
30
Set the Parallel Poll Enable Register to the value <nrf>.
Returns the value in the Parallel Poll Enable Register.
Recall Settings from store <nrf>.
Resets the instrument.
Set the Service Request Enable Register to <nrf>.
Returns the value of the Service Request Enable Register.
Returns the value of the Status Byte Register.
Save settings to store number <nrf>.
Examine the state of the FLT bit in the Status byte register and return the result.
Wait for operation complete true.
Set the output voltage to <nrf>.
Set the output voltage to <nrf> and verify.
Set current limit to <nrf>.
Set OVP to <nrf>.
Returns the set voltage in Volts.
Returns the current limit in Amps.
Returns the OVP value in Volts.
Reads and returns the voltage in Volts.
Reads and returns the output current in Amps.
Decrement the set current by the delta current value.
Decrement the output voltage by the delta voltage value.
Decrement the output voltage by the delta voltage value and verify.
Set delta Amps to <nrf>.
Set delta voltage to <nrf>.
Returns the delta current value in Amps.
Returns the delta voltage value in Volts.
Increment the set current by the delta current value.
Increment the output voltage by the delta voltage value.
Increment the output voltage by the delta voltage value and verify.
Returns the power being output from the instrument, in Watts.
Set the output status ON or OFF.
Sets the meter damping to OFF or ON.
Returns the value in the Limit Event Status Register.
Set the Limit Event Status Enable Register to the value of <nrf>.
Returns the value in the Limit Event Status Enable Register.