Aim TSX-P Series Bedienungsanleitung Seite 30

BUZZ
Sequential command.
Operation complete message generated immediately after execution.
Sounds the buzzer and sets the buzzer status to ON.
LRN #0<Indefinite Length Binary Block data><pmt>
Sequential command. (†)
Operation complete message generated immediately after execution.
Install all instrument settings from a previous ∗LRN? query. The response from a ∗LRN?
command is formatted such that the complete message may be returned to the instrument at any
time to restore the settings in effect when the ∗LRN? command was issued.
The scope of the LRN command is as follows;
The output is set to the values of Volts, current, OVP, delta V and delta A in the data block.
The output status is set to the value in the data block.
STO?
Sequential command. (†)
Operation complete message generated immediately after <rmt> is sent.
Returns the contents of the stores in the instrument as an Indefinite Length Binary Block. The
block is prefixed with the STO command and may thus be returned to the instrument to re-install
the stored settings.
The syntax of the response is
The size of the data block is instrument type dependent. The settings in the instrument are not
affected by execution of the STO? command.
STO #0<Indefinite Length Binary Block data><rmt>
Sequential command (†)
Operation complete message generated immediately after execution.
Install all stored data from a previous STO? query. The response from a STO? command is
formatted such that the complete message may be returned to the instrument at any time to
restore the data in effect when the STO? command was issued. The instrument settings are not
affected by the STO command but the contents of the stores are completely updated.
Remote Command SummaryCommon Commands
∗CLS
∗ESE <nrf>
∗ESE?
∗ESR?
∗IDN?
∗IST?
∗LRN?
∗OPC
∗OPC?
STO #0<Indefinite Length Binary Block data><rmt>
Clear Status.
Set the Standard Event Status Enable Register to the value of <nrf>.
Returns the value in the Standard Event Status Enable Register.
Returns the value in the Standard Event Status Register.
Returns the instrument identification.
Returns ist local message.
Returns the complete set up of the instrument.
Sets the Operation Complete bit in the Standard Event Status Register.
Returns the Operation Complete status.
29