Aim TSX-P Series Bedienungsanleitung Seite 22

∗ESR?
Sequential command.
Operation complete message generated immediately after <rmt> is sent.
Returns the value in the Standard Event Status Register in <nr1> numeric format. The register is
then cleared. The syntax of the response is
Example.
∗IDN?
Sequential command.
Operation complete message generated immediately after <rmt> is sent.
Returns the instrument identification. The exact response is determined by the instrument
configuration and is of the form
where <NAME> is the manufacturer's name, <MODEL> defines the type of instrument and
<VERSION> is the revision level of the software installed.
∗IST?
Sequential command.
Operation complete message generated immediately after <rmt> is sent.
Returns ist local message as defined by IEEE Std. 488.2. The syntax of the response is
if the local ist message is false or
if the local ist message is true.
∗LRN?
Sequential command.
Operation complete message generated immediately after <rmt> is sent.
Returns the complete set up of the instrument as a character data block. The block contains a
series of commands, separated by semi-colons, which specify the complete instrument set up
and may thus be returned to the instrument to re-install the set up. The syntax of the response is
The size of the character data block is instrument type dependent.
The settings in the instrument are not affected by execution of the ∗LRN? command.
∗OPC
Sequential command.
Operation complete message generated immediately after execution.
Sets the Operation Complete bit (bit 0) in the Standard Event Status Register. This will happen
immediately the command is executed because of the sequential nature of all operations.
If the Standard Event Status Register contains 01000001b the response to
∗ESR? will be 65<rmt>.
<NAME>,<model>P,0,<version><rmt>
LRN #0<Indefinite Length Binary Block data><rmt>
<nr1><rmt>
0<rmt>
1<rmt>
21