Aim TSX-P Series Bedienungsanleitung Seite 29

LSR?
Sequential command
Operation complete message generated immediately after <rmt> is sent.
Returns the value in the Limit Event Status Register in <nr1> numeric format. The register is then
cleared. The syntax of the response is
Example:
be 65<rmt>.
LSE <nrf>
Sequential command
Operation complete message generated immediately after execution.
Set the Limit Event Status Enable Register to the value of <nrf>. If the value of <nrf>, after
rounding, is less than 0 or greater than 255 an execution error is generated and error number
119 (Value out of range) is placed in the Execution Error Register.
LSE?
Sequential command
Operation complete message generated immediately after <rmt> is sent.
Returns the value in the Limit Event Status Enable Register in <nr1> numeric format. The syntax
of the response is
Example:
EER?
Sequential command
Operation complete message generated immediately after <rmt> is sent.
Returns the value in the Execution Error Register in <nr1> numeric format. The register is then
cleared. The syntax of the response is
QER?
Sequential command
Operation complete message generated immediately after <rmt> is sent.
Returns the value in the Query Error Register in <nr1> numeric format. The register is then
cleared. The syntax of the response is
BUZZER <nrf>
Sequential command
Operation complete message generated immediately after execution.
Sets the buzzer status to ON or OFF. If the value of <nrf>, after rounding, is 0 the buzzer status
will be set to OFF, if 1 the buzzer status will be set to ON. If the value of <nrf> is not 0 or 1
execution error 119 (Value out of range) will be generated.
28
If the Limit Event Status Register contains 01000001b the response to LSR? will
If the Limit Event Status Enable Register contains 01000001b the response to
LSE? will be 65<rmt>.
<nr1><rmt>
<nr1><rmt>
<nr1><rmt>
<nr1><rmt>