Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setting up
Connections
Using the automatic
power-on circuit
DC trigger switch on for
use with the
The two front speakers should be positioned in such a way that they and the
listener form the three points of an approximately equi-lateral triangle.
The minimum listening distance is two metres, and this should always be
observed. This means that the speakers should also be at least two metres apart in
order to satisfy the triangle rule.
It is essential to provide for unobstructed air circulation around the cabinet. The
space at the sides of the back panel and the top panel of the speaker cabinet
must be at least 10 - 15 cm.
Setting up the speakers in the immediate vicinity of a conventional (CRT) TV set
The KS ACTIVE loudspeakers should be positioned at least 1.0 metres from
any conventional television, otherwise they may cause discoloration of the TV
image. This restriction does not apply to LCD or Plasma TV sets.
Connect the mains sockets on the rear face of the loudspeakers using the mains
leads supplied; connect each plug to a separate switched mains outlet socket.
Connect the loudspeakers' Cinch or XLR audio inputs to the outputs of your
pre-amplifier.
Now switch on the speaker using the mains switch on the back panel.
The speakers are ready for use. A green LED lights up to indicate the ready
status. The LED is located behind the grille on the lower part of the front panel.
The balanced (XLR) and unbalanced (Cinch) audio inputs cannot be used at the
same time. Please make sure that no cables are plugged into the unused input.
The KS ACTIVE loudspeakers are fitted with an automatic power-on circuit
which turns the speakers on from stand-by mode when a music signal is
present, and turns them off again about twenty minutes after the music has
ended.
The automatic power-on circuit can only work if the mains switch on the back
panel is at the ON position (position 1).
The power consumption of the loudspeakers in stand-by mode is very low (less
than 1 Watt).
If you know you will not be using the speakers for a long period, disconnect
them completely from the main supply.
If you connect the speakers to a
KS ACTIVE can be switched on by a trigger signal from the device. In this case
the loudspeakers are always switched on with the device – not just when the
music starts. This eliminates the possibility of "swallowing" the initial beats of
the music.
Please select the necessary settings in the 'System Configuration menu' of
A
(for details see the
This special function is only available while the speaker is connected to the
audio input socket (non-balanced).
)
15
Multi-Source System then the
Werbung
Kapitel
Inhaltsverzeichnis
