RCF EVOX JMIX8 Bedienungsanleitung Seite 13

STEREO LINE input channel 5/6: connect to these TS jacks any analog stereo source.
9
Control the stereo channel level with the dedicated knob: The SIGNAL LED lights up in
green when a signal louder than -40dB is applied to the input. Pressing the INPUT button
gives the access to display menus:
Page LVL
LEVELS (LVL): as for the MONO channels, this menu page gives access to the channel FX
send, AUX send. BAL (balance) and channel MUTE controls are shown on the right side.
When pressed, the MUTE button also affects FX and AUX sends. The small rectangular
boxes on the bottom line, from left to right, indicate the absolute levels of FX send, AUX
send and Channel Level. All the other pages are same as MONO channels input.
STEREO LINE 7/8: connect to these RCA connectors any low level analog stereo
10
source (-10dBV). Control the stereo channel level with the dedicated knob: the SIGNAL
LED lights up in green when a signal louder than -40dB is applied to the input. Pressing
the INPUT button gives the access to display menus. The control pages of channels 7/8
are same as channel 5/6 except for the PRE page:
From the dedicated box called DUCKER it is possible to activate a ducker gate on
channels 7/8. The control key for the ducker is always the signal present on MIC input 1.
Channel 7/8 is also used for Bluetooth audio input.
MAIN LEVEL: MAIN LEVEL controls the master signal level; it provides a control level
11
knob and an OUTPUT button. The small yellow point named 0dB indicates the "unity
gain" level of the Main Mix. Press the button HOME (15) to show the METER page which
includes level metering of L-R output. Pressing the OUTPUT button gives access to the
following pages:
OUT page: in this page a drop down menu shows one of the four selectable mastering
presets. Rotate and press the EDIT encoder to select a different mastering preset:
1. MASTERING
2. MASTER BOOST
3. LOUD & PROUD
4. HI-FI
These presets combine the action of an Exciter and a Maximizer to apply nice dynamic
and frequency response improvement to the Master signal.
A dedicated box MP ON/OFF permits to turn on and off this feature.
The STEREO box ON/OFF allows to select the chosen system configuration: using the
EVOX JMIX8 as a stand alone speaker, the STEREO box has to be set to OFF. Using EVOX
8 JMIX8 + EVOX J8 as a stereo configuration, the STEREO BOX has to be set to ON. In
13