Herunterladen Inhalt Inhalt Diese Seite drucken

Set The Volume; Set Up Reception Sensitivity - Silvercrest SWED 500 A1 Bedienungsanleitung

Multi-band radio
Vorschau ausblenden Andere Handbücher für SWED 500 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Set the volume

By pressing the 'VOL-/AL1' (2) and 'VOL+/AL2' (3) buttons, you can change
the volume in accordance with your preferences. The settings range from a
minimum volume level of '00' to a maximum volume level of '16'. When being
used as a loudspeaker, the device starts at the volume that it was at when last
switched off.
In order to avoid hearing damage due to excessive volume, the volume settings
for use with earphones are regulated as follows:
 When the volume reaches level '07', the volume warning icon (33) begins to
flash. You can now only increase the volume further if you confirm the
volume warning by briefly pressing the 'LOCK' button (11). The increased
volume level will remain until the device is next switched off.
 If the volume level during use as a loud speaker was set as higher than level
'07' and earphones were then inserted during use as a radio, the volume will
jump back to level '07'. By pressing the 'VOL+/AL2' button (3) again, the
volume warning icon will begin to flash (33). You can now only increase the
volume further if you confirm the volume warning by briefly pressing the
'LOCK' button (11).
 If the volume level during use as a loud speaker or with earphones was set
as higher than level '07' and the device was then switched off, if it is
switched on again while earplugs are inserted, the volume will jump back to
level '07'. By pressing the 'VOL+/AL2' button (3) again, the volume warning
icon will begin to flash (33). You can now only increase the volume further if
you confirm the volume warning by briefly pressing the 'LOCK' button (11).

Set up reception sensitivity

This function only applies for FM and SW. If you wish to use the device in
normal mode, slide the 'DX/LOCAL' selection switch (23) to the 'DX' position.
If you only wish to receive stations with a high field strength, slide the
'DX/LOCAL' selection switch (23) to the 'LOCAL' position. This is recommended
if, for example, you wish to receive a weak local station that stronger national
stations are blocking out.
SilverCrest SWED 500 A1
English - 27

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis