Cleaning And Maintenance - Ferm HDM1014 Übersetzung Der Originalbetriebsanleitung

● Release the locking sleeve (5).
Mounting and removing the auxiliary grip (fig. C)
Mounting
● Loosen the auxiliary grip (7) by turning
it counterclockwise.
● Mount the auxiliary grip (7) by sliding it over
the chuck (4).
● Turn the auxiliary grip (7) to the required
position.
● Tighten the auxiliary grip (7) by turning
it clockwise.
Removing
● Loosen the auxiliary grip (7) by turning
it counterclockwise.
● Remove the auxiliary grip (7).
● Tighten the auxiliary grip (7) by turning
it clockwise.
Mounting and removing the depth stop (fig. C)
Mounting
● Loosen the auxiliary grip (7) by turning
it counterclockwise.
● Insert the depth stop (8) through the hole in
the auxiliary grip (7).
● Set the depth stop (8) to the required position.
● Tighten the auxiliary grip (7) by turning
it clockwise.
Removing
● Loosen the auxiliary grip (7) by turning
it counterclockwise.
● Remove the depth stop (8).
● Tighten the auxiliary grip (7) by turning
it clockwise.
Mounting and removing the dust collector
(fig. D)
The dust collector prevents dust from entering the
machine when drilling into ceilings.
2
Immediately replace a damaged dust
collector.
Mounting
● If necessary, remove the accessory from the
chuck (4).
● Slide the dust collector (15) over the shaft of
the accessory.
● Insert the accessory with the dust collector
(15) into the chuck (4).
Removing
● Remove the accessory with the dust collector
(15) from the chuck (4).
● Remove the dust collector (15) from the
accessory.
USE
Switching on and off (fig. A)
● To switch on the machine, press the on/off
switch (1).
● To switch off the machine, release the on/off
switch (1).
Setting the operating mode (fig. A & E)
The drill selection switch and the hammer
selection lever must be set according to the
required operating mode. Refer to the table below
to set the required operating mode.
Setting (fig. E)
A
B
C
● Turn the drill selection switch (2) and the
hammer selection lever (3) to the required
position.
Hints for optimum use
● Clamp the workpiece. Use a clamping device
for small workpieces.
● Firmly hold the machine by the grip.
● Set the operating mode.
● Switch on the machine.
● Do not apply too much pressure on the
machine. Let the machine do the work.
● Switch off the machine and wait for the machine
to come to a complete standstill before putting
the machine down.

CLEAnIng AnD MAInTEnAnCE

4
Before cleaning and maintenance,
always switch off the machine and
remove the mains plug from the mains.
● Regularly clean the housing with a soft cloth.
● Keep the ventilation slots free from dust and
dirt. If necessary, use a soft, moist cloth to
remove dust and dirt from the ventilation slots.
Lubrication (fig. A)
● Regularly grease the shaft in which the
Operating mode
Demolition hammer / Chisel
Hammer drill
Drill
7