Cleaning And Maintenance; Warranty - Ferm HDM1021 Übersetzung Der Originalbetriebsanleitung

Cleaning and maintenance

Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
• Regularly clean the housing with a soft cloth.
• Keep the ventilation slots free from dust and
dirt. If necessary, use a soft, moist cloth to
remove dust and dirt from the ventilation slots.
Lubrication
(fig. A)
• Regularly grease the shaft in which the
accessories must be inserted.
• Regularly check the grease level inside the
machine:
• Remove the cover from the lubrication
point (9) using a screwdriver.
• Remove the cap from the lubrication point
(9).
• If necessary, add some grease into the
lubrication point (9).
• Mount the cap to the lubrication point (9).
• Mount the cover to the lubrication point (9)
using a screwdriver.
Trouble shooting
Below we have listed a few probable causes and
solutions to which you can refer if your circular
saw does not function properly.
1. Machine fails to operate.
• Power turned off.
• (Extension) cable damaged.
2. The elektromotor hardly reaches maximum
speed.
• The extension cable is too thin and/or too
long.
• The mains voltage is lower than 230 V.
3. Machine overheats.
• Air vents are blocked. Clean them with a dry
cloth.
• The machine has been overloaded. Use the
machine for the purpose it is made for.
4. Excessive sparking or elektromotor runs
irregular.
• There's dirt inside the motor or the carbon
brushes are worn.
• Replace the carbon brushes or bring the
machine to a specialized repair centre.
Ferm

Warranty

Consult the enclosed warranty terms.
Environment
Disposal
The product, the accessories, and the
packaging must be sorted for
environmentally friendly recycling.
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
warranty card. In the back of this manual you find
an exploded view showing the parts that can be
ordered.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2002/96/EC for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.
EN
7