Ferm HDM1014 Übersetzung Der Originalbetriebsanleitung Seite 6

As the colours of the wires in the mains cable of
the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
- The wire which is coloured blue must be
connected to the terminal which is marked with
the letter N or coloured black.
- The wire which is coloured brown must be
connected to the terminal which is marked with
the letter L or coloured red.
TECHNICAL DATA
Mains voltage
Mains frequency
Power input
No-load speed
Impact rate
Max. drilling diameter
Wood
Steel
Concrete
Weight
NOISE AND VIBRATION
Hammer position
Sound pressure (L )
pa
Acoustic power (L )
wa
Uncertainty (K)
Vibration
Uncertainty (K)
Hammer/drill position
Sound pressure (L )
pa
Acoustic power (L )
wa
Uncertainty (K)
Vibration
Uncertainty (K)
2
Wear hearing protection.
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in EN
60745; it may be used to compare one tool with
another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
6
HDM1014
V~ 230
Hz 50
W 1,100
min 0 - 750
-1
min 0 - 2,920
-1
mm 40
mm 16
mm 30
kg 6.25
HDM1014
dB(A) 89
dB(A) 106
dB(A) 3
m/s 6.89
2
m/s 1.5
2
dB(A) 93
dB(A) 107
dB(A) 3
m/s 10.61
2
m/s 1.5
2
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
signifi cantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns
DESCRIPTION (fIg. A)
Your hammer drill has been designed for drilling
holes into wood, steel, and masonry. The
machine can also be used as a demolition
hammer in combination with the SDS chisels.
1. On/off switch
2. Drill selection switch
3. Hammer selection lever
4. Chuck
5. Locking sleeve
6. Main grip
7. Auxiliary grip
8. Depth stop
9. Lubrication point
10. Carbon brush holder
ASSEMBLy
4
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
Mounting and removing the accessory
(keyless chuck) (fig. B)
2
Do not use blunt drill bits or chisels.
Immediately sharpen or replace blunt
drill bits or chisels.
Mounting
● Apply a few drops of oil to the shaft of the
accessory.
● Slide the locking sleeve (5) to the rear.
● Insert the accessory into the chuck (4).
● Secure the accessory by turning it
counterclockwise until it locks into place.
● Release the locking sleeve (5).
Removing
● Slide the locking sleeve (5) to the rear.
● Remove the accessory from the chuck (4).