Items Supplied; Proper Use - EINHELL 43.080.30 Originalbetriebsanleitung

Anleitung_RT_SB_250_U_SPK7:_
Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.
1. Machine layout (Figures 1/2/8)
1. ON/OFF switch
2. Power cord
3. Rubber tires
4. Connection piece
5. Machine foot
6. Extractor connection, 100 mm diameter
7. Lower blade pulley
8. Upper blade pulley
9. Tightening screw
10. Extractor connection, 36 mm diameter
11. Upper blade guide
12. Side cover
13. Hood closure
14. Side cover
15. Saw table
16. Dial scale for tilt angle
17. Plastic table insert
18. Fixing handles for saw table
19. Angle stop
20. Fixing handle for blade guide
21. Retaining screw for upper blade pulley
22. Setting screw for upper blade pulley
23. Parallel stop
24. Machine housing
25. Blade
26. Tilt guard
27. Clamp lever
28. Push stick

2. Items supplied

Bandsaw
Machine table
Push stick
Parallel stop
Base frame
Blade
10.02.2012 9:57 Uhr Seite 19

3. Proper use

The bandsaw is designed to perform longitudinal and
cross cuts on timber or wood-type materials. To cut
round materials you must use suitable holding
devices. The machine is to be used only for its
prescribed purpose.
Any use beyond that mentioned is considered to be
a case of misuse. The user/operator and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse.
The machine is to be operated only with suitable saw
blades. To use the machine properly you must also
observe the safety regulations, the assembly
instructions and the operating instructions to be
found in this manual.
All persons who use and service the machine have
to be acquainted with this manual and must be
informed about the machineʼs potential hazards.
It is also imperative to observe the accident
prevention regulations in force in your area.
The same applies for the general rules of
occupational health and safety.
The manufacturer shall not be liable for any changes
made to the machine nor for any damage resulting
from such changes.
Even when the machine is used as prescribed it is
still impossible to eliminate certain residual risk
factors. The following hazards may arise in
connection with the machineʼs construction and
design:
Damage to hearing if ear-muffs are not used as
necessary.
Harmful emissions of wood dust when used in
closed rooms.
Contact with the blade in the uncovered cutting
zone.
Injuries (cuts) when changing the blade.
Injury from catapulted workpieces or parts of
workpieces.
Crushed fingers.
Kickback.
Tilting of the workpiece due to inadequate
support.
Touching the blade.
Catapulting of pieces of timber and workpieces.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
GB
19