Bosch sensixx B10L Gebrauchsanleitung Seite 12

en
In both cases, if you find that water is dripping out
of the soleplate, set the temperature selector (11) to
a higher position (take care that the garment can be
ironed on this heat temperature setting).
Cork handle iron (depending on the model):
To get permanent steam, press the lock button (15)
and slide it backwards until it locks. To switch off the
permanent steam, slide the lock button forward.
Important:
• The steam hose may get hot if you are ironing for
long periods.
Ironing without steam
1. Set the required ironing temperature.
2. Begin ironing but without pressing the steam
release button (12).
Vertical steam (C)
1. Set the temperature control to the «••» or «max»
position.
2. You can steam iron curtains and hanging
garments (jackets, suits, coats...) by holding the
iron in a vertical position and pressing the steam
release button (12).
Operate the iron vertically at a distance of 10 to
20 cm
Never direct the steam jet at garments that
are being worn.
Never aim the steam at people or animals.
Cleaning the Boiler
To extend the life of your steam generator and to
avoid any build up of scale, it is essential that you
rinse out the boiler after 10 uses. If your water is
hard, increase the frequency.
Do not use descaling agents for rinsing out the
boiler (unless they have been advised by Bosch),
as they could damage it.
1. Check that the appliance is unplugged and cold
for more than 2 hours.
2. Unscrew the boiler´s cap (1)
3. Empty the boiler above a sink by holding the
appliance upside down.
4. Fill the boiler with 500 ml of fresh water.
5. Shake the base unit for a few moments and then
empty it completely over a sink or bucket.
6. To obtain the best result, we recommend that
this operation is done twice
7. Close the cap
12
Cleaning & Maintenance
Important:
Always unplug the appliance from the mains
supply before carrying out any cleaning or
maintenance operation on it.
1. After ironing, pull out the plug and allow the
appliance to cool down before cleaning.
2. Wipe the housing, handle and iron body with a
damp cloth.
3. If the soleplate is soiled with dirt or scale, clean it
with a damp cloth.
4. Never use abrasive products or solvents.
Storing the appliance (D)
1. Set the main power to the «0» position and
disconnect the mains cable.
2. Always allow the appliance to cool down before
storing it.
3. Place the iron on the iron pad, standing on the
soleplate.
4. Empty the boiler and store the mains cable and
the steam hose in the storage compartment. Do
not wrap the cords too tight.
5. Use the carrying handles (17) on the sides when
moving the appliance.