Setting The Temperature - Bosch sensixx B10L Gebrauchsanleitung

the appliance and place the iron on it on another
solid, stable, horizontal surface. Never rest the
iron on the appliance without the iron pad!
3. Open the boiler´s cap (1). Fill the boiler carefully
using always the funnel, and close the cap
firmly.
Filling with warm water reduces the waiting time
for heating up.
Do not overfill the boiler.
4. Unwind the mains cable (4) fully and plug it into
an earthed socket.
5. Switch the main power button (9) on (position
"I")
6. The "Steam ready" indicator lamp (6) will light up
after approximately 7 minutes, indicating that the
appliance is ready to use.
7. This appliance has a water level sensor. The
"Refill boiler" indicator (7) will light when the boiler
is empty.
Refilling the boiler
Attention! Risk of burns!
Be careful when opening the cap, steam may
escape.
If the pilot lamp (7) illuminates :
1. Press the steam button (12) to check that no
more steam is generated. Only then the boiler
should be refilled.
2. Set the appliance switch (9) to the off position
("0") and unplug the steam station from the
mains. Then wait for minimal 2 minutes.
3. Open the cap (1) carefully and slowly. Allow
remaining steam to escape.
4. Refill the boiler using always the funnel. Do not
overfill the boiler.
5. If there is water left around the filling inlet, please
dry with a towel before closing the boiler.
6. Close the cap firmly.
Important:
• Normal tap water can be used.
To prolong the optimum steam function, mix tap
water with distilled water 1:1. If the tap water
in your district is very hard, mix tap water with
distilled water 1:2.
You can inquire about the water hardness with
your local water supplier.
• To avoid damage and/or contamination of the
boiler, do not put perfume, vinegar, starch,
descaling agents, additives or any other type
of chemical product into the boiler, unless they
have been advised by Bosch
• The iron pad (2) can be placed into the specially
designed recess on the appliance or somewhere
suitable alongside the ironing area.
Never rest the iron on the appliance without
the iron pad!.
• During it first use the iron may produce certain
vapours and odours, along with white particles
on the soleplate, this is normal and it will stop
after a few minutes
Setting the temperature
1. Check the ironing instruction label on the garment
to determine the correct ironing temperature.
2. Select the temperature (11):
«•»
«••»
«•••» Cotton-Linen
3. The indicator lamp (13) will remain lit while the
iron is heating and go out as soon as the iron has
reached the selected temperature.
Tips:
• Sort your garments out based on their cleaning
symbol labels, always starting with clothes that
have to be ironed at the lowest temperatures.
• If you are not sure what the garment is made
of then begin ironing at a low temperature and
decide on the correct temperature by ironing a
small section not usually seen when worn
Ironing with steam (B)
1. Turn the temperature selector (11) to the required
setting
2. Set the amount of steam to suit your needs,
using the variable steam control (8) (depending
on the model).
3. Press the steam release button (12) to release
steam.
Attention:
When ironing on a lower temperature setting «•».
• If the appliance has variable steam control (8), set
the variable steam control to its lowest position
(« »).
• If the appliance does not have variable steam
control, press the steam release button (12) only
for a few seconds at a time when ironing at lower
temperatures.
en
Synthetics
Silk-Wool
11