Fault
Hedge trimmer does not work.
Hedge
trimmer
cuts
interruptions
Motor is running, knives do not
move
Knives get hot
Motor is humming, knives do not
move
In case of further faults or inquiries please contact your local dealer.
Type / Model
Year of construction
Motor output P
1
Mains voltage / Mains frequency
No-load speed n
0
Length of knives
Cutting length
Cutting distance
Hand-arm vibration according to EN 60745
Front handle
Rear handle
Measuring uncertainty K
Measured sound power level L
Guaranteed sound power level L
Sound pressure level L
PA
Measuring uncertainty K
Working length (with telescopic tube) min. – max approx.
Weight (with telescopic tube) approx.
Protection class
Possible faults
Possible cause
No power
Power failure
Extension cable defect
Safety fuse defect
Motor or switch defect
with
Cable defect
Internal failure
Circuit closer/breaker defect
Internal failure
Knives are edgeless
Knives are defect
Missing lubrication => friction
Knives are blocking
Technical Data
wa
wa
Removal (disconnect power plug)
Check cable, no longer use defect cable protection
Check cable, no longer use defect cable protection
Check power supply, power outlet, fuse
Replace fuse
Have motor or switch checked by an approved
electrician or replaced by original spare parts
Check cable, no longer use defect cable protection
Manufacturer
service respectively must be called
Manufacturer or responsible customer service
respectively must be called
Manufacturer or responsible customer service
respectively must be called
Arrange sharpening of knives
Exchange knives
Lubricating of knives
Remove object
HHS 710/56
see last page
710 W
230 V~ / 50 Hz
1800 min
560 mm
510 mm
27 mm
a
= <5.237 m/s²
vhw
a
= <3.543 m/s²
vhw
K = 1.5 m/s²
95 dB (A) (according to regulation 2000/14/EC)
102 dB (A) (according to regulation 2000/14/EC)
84 dB (A) (according to regulation 2000/14/EC)
K = 3.0 dB (A)
min. 2.35 – max. 2.87 m
min. 1.53 – max. 2.05 m
3,9 kg (4,9 kg)
II
or
responsible
customer
–1
23