Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Stretch a guide over the complete length of the hedge when
you want to shorten the upper edge of the hedge evenly.
The maximal diameter to cut depends on the wood's type,
age, moisture and hardness.
Therefore cut very thick branches using branch shears
to your desired length before trimming the hedge.
Trim in several passes if you have to cut down a large
portion of the hedge.
Using the telescopic handle
Use the telescopic handle to trim high and wide hedges as well
as ground-cover plants. (See chapter "Assembly", section
"Telescopic handle".)
High hedges:
Turn the cutting head to your desired position and hold the
hedge trimmer in vertical position.
Have breaks when working above your head to
prevent bodily fatigue.
Wide hedges:
Turn the cutting head to a working range from 0 to 10
degrees and guide the hedge trimmer horizontally in a
pendular movement to the hedge edge.
Ground-cover plants (working near the ground)
Turn the cutting head to the 0 degree position.
Always use the telescopic handle for trimming
ground-cover plants.
Maintenance and Care
Remove the plug from the power socket
before starting any maintenance or
cleaning work.
Maintenance and repair work other than those described in this
chapter is only allowed to be carried out by service staff.
For maintaining and cleaning, removed security devices must
unconditionally be mounted properly and proved again.
Use only original parts. Other parts can result in unexpected
damages and injuries.
Maintenance
The cutting tool will not come to a standstill immediately after
cut-off. Before starting any service work wait until all parts are
stationary.
To guarantee a long and reliable usage of the product carry out
the following maintenance works regularly.
Check the machine for obvious defects such as
loose, hung out or damaged cutting tools
worn or damaged components
correct assembly and faultless covers and protective
devices.
22
Necessary repair works or maintenance have to be carried
out before using the power tool.
Clean the machine and its accessories thoroughly after
each application so that the faultless function is kept.
Clean the case with a soft brush or a dry cloth.
Water, solvents and polishing agents shall not be
applied.
Clean the cutting device on a regular basis using a brush or
a cloth.
Never clean the knives with water
Risk of corrosion!
Oil the cutting tools regularly. Never use any grease
Use environmentally friendly oil.
Keep handles dry and free of oils and grease.
Remove the mains plug from the socket.
Store unused equipment in a dry, locked place out of the
reach of children.
To extend the service life of the hedge trimmer and
guarantee smooth operation, before storing for a longer
period
thoroughly clean the hedge trimmer
-
treat all movable parts with an environmentally friendly
-
oil
Never use any grease!
Push the knife protection on the knife.
Guarantee
Please observe the enclosed terms of guarantee.
Cleaning
Storage
Werbung
Kapitel
