After Use; Cleaning And Care; Cleaning; Maintenance - FLORABEST FALH 40-Li A1 Originalbetriebsanleitung

1. First cut into the branch from below outside
the place where you intend to cut off the
branch. The cut should go from one third to
halfway through the branch (see Fig. P).
2. Cut into the branch from the top outside at the
same height the branch is sawn from top
(see Fig. Q).
3. Last, cut off the stump with one clean cut from
top to bottom (see Fig. R).
4. You might want to seal the cut with a suitable
compound.

After use

Q
1. Switch the product off, remove the battery
pack and let it cool down.
29
2. Check, clean and store the product (see

"Cleaning and care").

Cleaning and care
Q
WARNING!
Always switch the product off, remove
the battery pack and let the product
cool down before performing inspection,
maintenance and cleaning work!

Cleaning

Q
The product must always be kept clean, dry
o
and free from oil or grease. Remove debris
from it after each use and before storage.
Regular and proper cleaning will help ensure
o
safe use and prolong the life of the product.
Inspect the product before each use for worn
o
and damaged parts. Do not operate it if you
find broken and worn parts.
Never allow fluids to get into the product.
o
Clean the product with a dry cloth. Use a
o
brush for areas that are hard to reach.
In particular clean the air vents after every
o
use with a cloth and brush.
Remove stubborn dirt with high pressure air
o
(max. 3 bar).
NOTE
Do not use chemical, alkaline, abrasive or
u
other aggressive detergents or disinfectants
to clean this product as they might be harmful
to its surfaces.

Maintenance

Q
Before and after each use, check the product and
accessories (or attachments) for wear and damage. If
required, exchange them for new ones as described
in this instruction manual. Observe the technical
requirements (see "Technical data").
Lubricating the saw chain
Lubricate the saw chain
o
after 1 hour of use or at least once weekly,
depending on which comes first.
Before lubricating, the guide bar
o
cleaned thoroughly, in particular the teeth of the
rail (see "Cleaning").
Lubricate the individual chain links with the aid
o
of an oil suction gun with pinpoint tip. Place
individual oil drops onto the articulated links and
onto the tooth tips of the individual chain links.
Guide bar inspection
Regularly inspect the guide bar
o
Remove burrs and straighten the guide surface
o
with a flat file.
Clean the oil passages (see "Cleaning").
o
Repair
Q
This product does not contain any parts that can be
repaired by the user. Contact an authorised service
centre or a similarly qualified person to have it
checked and repaired.

Storage

Q
Switch the product off and remove the battery
o
pack .
29
Clean and maintain the product as described
o
(see "Cleaning" and "Maintenance").
Store the product and its accessories in a dark,
o
dry, frost-free, well-ventilated place.
Always store the product in a place that is
o
inaccessible to children. The ideal storage
temperature is between 10 °C and 30 °C.
Attach the guide bar cover
o
We recommend using the original package for
o
storage or covering the product with a suitable
cloth or enclosure to protect it against dust.
Regularly check the charge level of the battery
o
pack, if it is to be stored for an extended period.
Optimum storage conditions are cool and dry.
after cleaning,
17
16 must be
16 for wear.
.
27
GB 19