Operation; Saw Chain Stop Test; Adjusting Pole Length; Harness - FLORABEST FALH 40-Li A1 Originalbetriebsanleitung

Testing chain lubrication
NOTE
Check the chain lubrication before each use.
u
1. Switch on the product (see "Switching on")
and hold it above a bright background. The
product must not touch the ground. If an oil
trace can be seen, the product is working
trouble-free.
2. If no oil trace can be seen, clean the oil
passages of the guide bar
guarantee a trouble-free, automatic oiling of
the saw chain during operation. Use a
17
brush or a cloth to help remove residues from
the oiling port .
21

Operation

Q
WARNING!
This product has not been designed to
u
provide protection from electric shock in the
event of contact with overhead electric lines!
Therefore do not use product near cable,
electric power or telephone lines. Keep a
minimum distance of 10 m to all electric lines
(see Fig. F)!
CAUTION! RISK OF INJURY!
Keep your hands away from the tool when
u
the product is in operation.

Saw chain stop test

Q
The product must always be held with two hands
when switching it on.
1. Hold the product with one hand on the
gripping surface
10
rear handle .
1
2. When switching on, ensure the saw chain
/
17
guide bar does not touch any objects.
16
3. Release the on / off switch
product off. The saw chain must come to a
stop.
, in order to
16
and with the other on the
to switch the
2

Adjusting pole length

Q
WARNING!
The length of the pole extension is limited!
u
Stop pushing / pulling as soon as you feel a
resistance!
Extend the extension only to the length
u
required to reach the hedges being cut! Do
not attempt to use the product at a length
which does not allow you to achieve proper
footing and balance at all times!
1. Disengage the locking lever
2. Adjust the length by pulling / pushing the
pole extension
13
(see Fig. G).
3. Engage the locking lever
secure the pole extension

Harness

Q
WARNING!
Always attach the product to the harness. Do
u
not carry it only with your hands!
The harness helps the operator to carry the
9
product. Attach the harness onto the product
before each use.
1. Lift the product and hold it firmly while
placing the harness over your shoulder (see
Fig. H).
2. Ensure the position of the product is properly
balanced.
3. Adjust the length of the harness to the desired
position.
4. In case of emergency, release the on / off
switch , press both latches on quick
2
release and then remove the harness
your shoulder.

Switching on and off

Q
Switching on:
1. Ensure the saw chain
not touch any objects. Remove the guide bar
cover 27 from the saw chain
bar before switching the product on.
16
.
12
out of / into the pole
11
afterward to
12
in position.
13
from
9
/ guide bar does
17 16
/ guide
17
GB 17